The SteelNavy.Com Message Board: Re: Your preferred method of prepping photo etch ?

[ Post a Response | The SteelNavy.Com Message Board ]

Re: Your preferred method of prepping photo etch ?

Posted by John Sykes on May 7, 2022, 18:16:26, in reply to "Your preferred method of prepping photo etch ?"

Hi.

In terms of prepping any photo etch prior attaching it to the model I may wipe the frets down with Turps using a lint free cloth if I can feel or see that the fret looks oily.

Mostly, I just spray the fret with paint using my airbrush, allowing to dry off for a day or so before attaching to the model.

No issues doing it for years this way and I note the differing ways other modellers prep their PE which I may try out.

Previous Message

I've almost exclusively used fine grit sanding paper & sanded in one direction, versus back n' forth, as to not damage parts.
I have the USS LANGLEY CV-1 in my posession (Loose Cannon, 1:700), which is making me re-think my sanding method for this kit....
Enter vinegar. How long to set brass (or stainless) in vinegar to get some "tooth" into the surface ? And how to wash it up afterward ? Is washing after vinegar even neccessary ?
Opinions are always greatly appreciated- and have a great weekend, all y'all !! From me all to you all, y'all....🚬😎

There are no responses to this message.

« Back to index

Post a Response

Your Name:

Subject:

Message:

[quote] Hi. In terms of prepping any photo etch prior attaching it to the model I may wipe the frets down with Turps using a lint free cloth if I can feel or see that the fret looks oily. Mostly, I just spray the fret with paint using my airbrush, allowing to dry off for a day or so before attaching to the model. No issues doing it for years this way and I note the differing ways other modellers prep their PE which I may try out. [quote] I've almost exclusively used fine grit sanding paper & sanded in one direction, versus back n' forth, as to not damage parts. I have the USS LANGLEY CV-1 in my posession (Loose Cannon, 1:700), which is making me re-think my sanding method for this kit.... Enter vinegar. How long to set brass (or stainless) in vinegar to get some "tooth" into the surface ? And how to wash it up afterward ? Is washing after vinegar even neccessary ? Opinions are always greatly appreciated- and have a great weekend, all y'all !! From me all to you all, y'all....🚬😎 [/quote] [/quote]

Notify me by email of all message replies.

By posting, you confirm that you have read and agree to the board's usage terms.

SteelNavy.Com Home Page