[ Post a Response | The SteelNavy.Com Message Board ]
I have been using.....
a Xuron set of PE cutters... I have had GREAT Success using it!!
If this image comes out.....look at the platforms where the rails are located, if you notice, a set of railings have been 'cut down' (instead of three-bar...cut down to two-bar)
I used my PE cutters to trim the needed rails. Been using these cutters for over a decade!!
I've always struggled removing 1/700 P/E parts from the sheet they are attached to. What are some of the techniques and tools fellow modelers have had success with?
SteelNavy.Com Home Page