[ Post a Response | The SteelNavy.Com Message Board ]
Re: Wanted: tutorial on bending tiny brass tubing and flaring the ends for use as funnel piping....
put tape on 1 end, fill tube with sand, tape close other end of tube & start bending. check hardware store for small pipe flaring kit to flare end of pipe.
Can anyone recommend an online tutorial for bending tiny diameter brass tubing (without the tubes crimping) and introducing a flare into the open end, to replicate piping on ship's funnels in 1/700 scale?
Any help would be greatly appreciated.
SteelNavy.Com Home Page