My fuse box has two fuses at the top (so no "middle fuse") and the 20 amp right hand side is marked C/H.
It was good. I checked for power at the connector just before the carb and no power (light blue/aqua colour). The wire vanishes into the harness and I could not see it at the bulkhead connector.
I ended up jumping power from the carb base plate heater. (2 big thick heavy gauge wires at the water temperature controlled switch in the intake)
It works for now. Going to check it in the spring.
a side note, I did notice performance gains by removing the heater plate below the carb, more airflow)
Message Thread
« Back to index