Nice job, at least the metal looks solid, not a bunch of tinworm turds...
Glen
I've been working on the front lower valance, doing some metal work on it as it has lots of blemishes. In one location it was 90* in two different directions.
I used hammer & dolly and a stump, shrinking disc,
This bit was last weeks work, but I found someone staring back at me.
I bumped the lows up and hit the highs with the shrinking disc.
Right side up. Looking better. The face is basically gone, and the spot under the notch is much better, even though it has some deep pits. This was the location it was bent and mangled.
And the other side.
Responses