If it has the later collapsible spacer, it's possibly overtightened causing too much preload/loss of backlash.
In either case, if the noise is new, after the seal change, I think the pinion location has shifted, and a teardown is necessary to set it all back up again.
Glen
--Previous Message--
: I replaced pinion oil seal on mk2, and
: rear makes noise. I had trouble getting
: u-joint flange in far enough to get the
: nut started-tapped it in.
: I believe that I have the same # of
: threads showing on the shaft as it was
: when I started.
: The car has a GMv-6 in it.
: I have a diff from a GT6, but no idea
: of its condition.
:
Responses