But I would urge a final, conclusive check, to measure the dome volume in the bore, by buretting it.
Removes all doubt about difficult measurements of dome parameters, complex formulae and calculations.
John
--Previous Message--
: Did you mean CRC?... which is just a
: book. I used my CAD package to verify
: the formula in my CRC handbook.
: However, CAD is only as accurate as the
: model you make and that requires
: assumptions along the way. Still... it
: can be a good sanity check.
:
: Doug L.
:
:
: --Previous Message--
:
: I'd be most grateful to have your CDC
: work out the volume! If it doesn't
: agree, I'll haveto go back to pen and
: paper and trigonometry!
: John
:
:
:
Responses