Too bad you are located so far away, I'd be glad to help you do the work in my shop.
--Previous Message--
: All good stuff. Thanks guys. I'm sure
: the rest will fall into place when I
: actually get to bust the case open.
: Right now I'm just looking at diagrams.
: Doesn't sound too bad though. Finding
: a machinist to do the cutting,
: grinding, boring and interference fit
: on the hybrid shaft will be the
: challenge.
:
: Ciao! - Jim
:
: --Previous Message--
: It has been about 20 years since I
: replaced parts in our GT6 gearbox. I
: remember doing exactly as Carter said
: regarding a temporary short shaft to
: keep the needle bearings in place. I
: was not smart enough to look for
: something at the hardware store and
: instead had the machinist at work make
: me a rod of the correct diameter. The
: pipe is a much easier and better
: solution.
:
: Doug L.
:
:
:
:
:
Responses