But if you decide to do it, please let us know how it turned out.
BTW, when removing parts from sprues, I recommend that you do it inside a box, as it reduces the risk of parts flying off, never to be seen again. Previous Message
I recently purchased a 3D printed IKOMA from SS Models. I haven't removed anything from the support lattice yet, but I can already see how delicate some of the parts are.
I read somewhere that giving it a coating of epoxy paint would really strengthen the parts. From what I've found on-line, the paint is a lot more expensive than the model. Has anyone done this? What epoxy spray paint did you use? Any information from real experience would be appreciated.
206
Message Thread
« Back to index