[ Post a Response | SurfJet Exchange ]
Posted by Leon Ward Leon --Previous Message--
on 8/20/2005, 6:27 pm, in reply to "Re: Carb issue"
66.188.71.68
Yes... however does anyone know which way the Brass Tube IN the carb goes? The one that goes through the center of the carb from the air mixing jet to the intake jet. I see it has a small hole about a quarter of an inch up. Does this hole go down in the bowl or up in the air channel?
: The brass tube?....the inlet on the top of the
: carb is the point of attachment for the
: primer... The tube on the bottom is the
: float bowl drain...it should have tubing
: attached which exits the fuel outside of the
: engine compartment...to drain the float
: bowl, turn the screw counter clockwise....
:
:
: --Previous Message--
: Does anyone know if the brass tube in the
: carb
: goes in with the air hole at the top so its
: in the intake channel or at the bottom so it
: is in the bowl?
:
:
:
Message Thread:
« Back to thread