[ Post a Response | SurfJet Exchange ]
Posted by Rowdy RT --Previous Message--
on 7/28/2005, 11:33 pm, in reply to "Can't get full throttle???????"
69.227.89.79
Johnny....Your post does not say if your throttle advances the carb completely...squeeze the throttle with the engine covers off and watch the action on the carb throttle body...when the motion stops and with the handle still depressed, see if you can advance the carb any further....If you can move it further, you still have air or a leak in your system...If not, your carb/fuel system is mucked up, low compression, bad ignition etc....hope for a leak in the throttle.....way easier to repair..
: I have got my board up and running very nice,
: but now I can't seem to get it 100% of its
: power. Runs,starts great just not getting
: all the power that it has (prob 50% power) .
: Is it possible that the hydraulic
: line/piston has a leak and will not fully
: engage??? Is there a quick/cheap way to fix
: this if it is a hydraulic problem??? Also I
: have bled the line, I can do it again what
: type of hydraulic oil is suggested to add
: when bleeding?? Just would like any
: feedback on why I can't get full power?????
: Thanks
:
Message Thread:
« Back to thread