[ Post a Response | SurfJet Exchange ]
Posted by mario --Previous Message--
on 6/27/2007, 4:09 pm, in reply to "problem pulling motor"
71.117.72.189
The bolts on the bottom thread directly into the pump housing, there are now nuts at the end. If they are spinning and unable to be pulled from the bottom you will need to drill off the heads, they are stripped in the housing and there is no way to access the housing while it is on the board.
: I have a 255cc malibu surfjet and I'm new at
: working on the motor. I'm trying to pull
: the motor but the mounting screws just keep
: turning like they are stripped out. Idont
: see any way of there being a nut on the
: bottom as there is no way to access the
: bottom. I donT have a manual for it. Know
: where to get one. aNny help would be greatly
: appreciated!!!!!!!!!
:
Message Thread:
« Back to thread