New owner of 28 gauge needs help
Posted by Larry Bell on August 26, 2017, 7:30 pm
I recently acquired a 28 gauge in disassembly and need of reassembly & a few parts. Is there a shop or two that I can be referred? Regards,
Re: New owner of 28 gauge needs help
Posted by Phil on August 26, 2017, 8:56 pm, in reply to "New owner of 28 gauge needs help"
Larry are you sure its a 28? What state are you located in? Jerry Andrews at 304-281-5776 in W Virginia may be able to help.
Posted by Larry on August 31, 2017, 9:25 pm, in reply to "Re: New owner of 28 gauge needs help"
No, I am not sure. I am helping a friend, too. Guess I should have measure the bore. I am in TX. Near Dallas. Thanks for the lead.
Posted by Larry Bell on September 9, 2017, 3:31 pm, in reply to "New owner of 28 gauge needs help"
Yes, it is a 16. Almost all back together. Will be contacting Mr. Andrews for advice & assistance. Thank you.
Posted by Larry Bell on November 9, 2017, 8:53 pm, in reply to "Re: New owner of 28 gauge needs help"
Gentlemen, Just an FYI that I have fully put back together my 16 SXS. I obtained the assistance of a Dallas master machinist and he has assembled my 16 to awesomeness. This weekend I will be smelling gunpowder.
« Back to index
Post a Response
Optional Image URL:
Optional Link Title:Optional Link URL:
Please enter the numbers above. This helps stop spam.By posting, you confirm that you have read and agree to the board's usage terms.