Re: looking for screws for lc smith Archived Message
Posted by David Williamson on March 2, 2013, 12:34 pm, in reply to "Re: looking for screws for lc smith"
I believe the heads are over-length and have a slot in them. Once in an tightened, you have to mark the orientation of the new slot, put them in a lathe or have the patience to file them, then cut the slot to the correct timing. The top tang to trigger plate housing has to be shaped with the slant of the top tang and cannot be too tight as it will bind the trigger to the sears. I almost "buggered" this one but had some more filing to get it flush with the top tang.
|
|