Posted by Chris Baumohl on August 31, 2007, 11:03 pm, in reply to "take apart"
This would take about 5 minutes to show you and will probably take 30 minutes to write but here goes...
Open and then close the gun to make sure it is cocked.
"Roll" the "half wheel" toward the end of the barrels. While it is "rolled" as far forward as it will go, lift the end of the forend and it will come off. Then push the top lever of the gun to the right until it stops and the barrels will drop. Lift them out of the receiver and you are done. Assembly is in reverse. Don't force anything.
Just be careful and you won't have any problem. You could go to the local sporting clay's club or skeet club and someone there is sure to know what they are doing.