Posted by Matt Felstead That was the problem, thank you very much for your help - much appreciated! Many thanks Matt --Previous Message--
on November 10, 2005, 15:08:48, in reply to "Re: Flash H8/3687"
82.110.144.51
Hi
: Hi,
:
: The problem is probably down to the
: FLASHE bit not being set in the FENR
: register. Setting this bit enables
: access to the flash registers. I
: imagine the E7 firmware sets this
: bit so it can program the flash and
: leaves it set so your code works
: with the debugger. When running
: standalone it is not set and so the
: flash cannot be erased or
: programmed.
:
: GA.
:
: --Previous Message--
: Hi All
:
: I've created a project based on App
: note 181 (User Mode Flash
: Programming). When connected to the
: E7 in debug mode the project
: operates correctly. When I attempt
: to download and run without the
: debugger the Flash is not Erased or
: Written to - the erase/program
: functions execute, but the Flash
: block to be erased/written remains
: unchanged.
:
: I note that others have had similar
: problems before, they were using the
: H83664. They solved the problem by
: downloading an upgrade from
:
: http://www.hmse.com/products/lem/support.htm
:
: This site is no longer available.
:
: Any ideas?
:
: Many thanks
:
: Matt
:
:
:
Message Thread:
« Back to thread