Posted by GA on November 9, 2005, 10:50:56, in reply to "Flash H8/3687" The problem is probably down to the FLASHE bit not being set in the FENR register. Setting this bit enables access to the flash registers. I imagine the E7 firmware sets this bit so it can program the flash and leaves it set so your code works with the debugger. When running standalone it is not set and so the flash cannot be erased or programmed. GA. --Previous Message--
62.73.170.19
Hi,
: Hi All
:
: I've created a project based on App
: note 181 (User Mode Flash
: Programming). When connected to the
: E7 in debug mode the project
: operates correctly. When I attempt
: to download and run without the
: debugger the Flash is not Erased or
: Written to - the erase/program
: functions execute, but the Flash
: block to be erased/written remains
: unchanged.
:
: I note that others have had similar
: problems before, they were using the
: H83664. They solved the problem by
: downloading an upgrade from
: http://www.hmse.com/products/lem/support.htm
:
: This site is no longer available.
:
: Any ideas?
:
: Many thanks
:
: Matt
:
Message Thread:
« Back to thread