Posted by GA on January 5, 2005, 15:47:12, in reply to "H8S2357F - SCI Initialisation" The delay does not exactly have to be 1 bit in length. Just at least 1 bit in length. Just use a for loop to count to a large number to provide the delay. Best to test that the delay is long enough - perhaps by using it to toggle a pin the frequency of which can be measured. GA. --Previous Message--
62.180.104.118
Hi,
: Hi,
:
: In the hardware manual, it specified
: a 1 bit wait before setting the TE
: (Transmit enable and RE (receive
: enable) bits. However, I have
: totally no idea how to implement
: this 1-bit wait. Does anyone have an
: idea how to code this 1-bit wait?
: i.e. either in C or Assembley?
:
: Thanks in advance.
:
: Regards,
: John
:
:
Message Thread 
« Back to index