Re: HCAN 2612

Posted by GA on February 23, 2004, 12:14:46, in reply to "Re: HCAN 2612"
194.131.190.1

Hi, Take a look at the IRR0 section of the apps note. The IRR0 interrupt occurs when the HCAM module is reset and is not maskable. So, when you enable the HCAN module in the module stop register an interrupt is generated. If there is no valid handler for this interrupt then the system is likely to crash. GA. --Previous Message-- : THX. : This Link has been a great help, but : whenever i enable HCAN in the MSTPCRC : register my processor stops executing : my source code only some interrupts : are working. Can anybody help me??? : THX : Robert : :

---

Message Thread: HCAN 2612 - Robert February 18, 2004, 12:43:55 Re: HCAN 2612 - GA February 18, 2004, 13:14:35 Re: HCAN 2612 - Robert February 20, 2004, 12:10:57 Re: HCAN 2612 - GA February 23, 2004, 12:14:46 « Back to thread

---

Post a Response

Evaluation Kit Support
Renesas Evaluation Boards are intended for evaluation of Renesas microprocessors only, not as development tools.