Posted by GA on February 4, 2004, 9:45:54, in reply to "FDT failure on notebook pc!" May be stating the obvious but you are connecting the serial port from the PC into the correct SCI port on the EVB. For the EVB2623 this is SCI2. From the log file you have configured FDT to use the UPB (universal programming board) interface. This is the small board in the corner of the EVB. The log file would indicate that FDT is unable to communicate with this board. So, it might be worth checking that the jumpers on this board are set correctly, i.e. not in bypass mode. Also, the serial cable connecting the PC to the EVB should be the straight type and not twisted (NULL modem). Hope this helps, GA --Previous Message--
194.36.128.105
Hi,
: Hi!
: I have some problems reprogramming
: the flash of my EVB2623F board. First
: I tried FDT v1.5, but it didn't
: manage to connect. I read the
: Known_problems.txt file, and tried
: the serial port fix mentioned there
: because I run this on a notebook pc.
: But it didn't help, so I tried FDT
: v3.1 instead (with the Protocol A
: plug-in to support my EVB). I still
: have problems to connect though, and
: v3.1 doesn't feature any serial port
: fixes. Here's my log from v3.1:
: Connecting to device 'H8S/2623F' on
: 'COM1'
: Configuration: 'BOOT Mode' connection
: using the HMSE Universal Programming
: Board
: Opening port 'COM1' ...
: Loading Comms DLL
: Loaded Comms DLL
: Looking for running kernel...
: Unable to download DeviceID from
: target
: No running kernel found, booting
: device...
: Resetting interface
: Taking RESET line low (Reset On)
: Enabling 12V supply
: Enabling Vpp supply
: Enabling MDx
: Taking RESET line high (Reset Off)
: Booting FZTAT device
: Error No 15005: 'COM1:' read time out
: Using micro-Kernel :
: 'D:\Voodoo\FDT3.1\Kernels\ProtA\2623\Hitachi\0_0_00\uGen2623.cde'
: Error No 15032: Interface failed to
: respond
: Error No 15019: Download() failed
: Error No 15005: 'COM1:' read time out
: Error No 15035: Unable to get version
: information from interface
: Unloaded Comms DLL
:
: Anyone else experienced the same
: problems?
: Regards
: Henrik
:
:
:
Message Thread
« Back to index