Posted by Roger Harper I am using Protocol A because I wanted to use the UPB instead of a direct connection. I also had to compile the kernel sources because Hitachi doesn't provide binaries for the 3062BF chip. I am able to communicate with the chip now, and things look OK. Roger. --Previous Message--
on September 30, 2003, 16:04:56, in reply to "Re: H8/3062BF and FDT"
66.239.118.226
Thanks for the info.
: Roger,
: The 3062BF is a B mask (0.35um)
: device. As such, use the protocol B.
: Protocol A is for 0.6um devices and
: there is a fundemental difference
: between the FLASH 0.35 & 0.6 um
: technology.
: This could be why you are having
: problems.
: In addition, when you create the
: FDT2.2 workspace, ensure that the
: specified XTAL frequency matches that
: of your device. The FDT2.2 default
: XTAL is 25MHz.
: If using FDT in direct connect mode (
: This is the best way to use FDT )
: ensure that the device is in boot
: mode!! Sounds obvious, but many
: people don't do this.
: Hope this helps.
: --Previous Message--
: Does anyone have any experience using
: FDT to program the H8/3062BF device.
: I'm working on a project and I'm
: trying to use FDT2.2 to program a
: 3062BF device. I'm not sure what I'm
: doing wrong, but FDT 2.2 refuses to
: connect. It gives a read timeout
: error when it tries to reset the
: interface. I am using protocol A,
: with a baud rate of 38400bps.
: Does anyone have any idea where I
: could be going wrong? Any advice
: would be welcome.
: Thanks,
: Roger Harper
: :
:
Message Thread:
« Back to thread