Posted by GA on February 6, 2003, 8:02:23, in reply to "FDT and the 2633F" How do you know the flash is blank? If the flash was worn out FDT would report an erase or programming failure. GA --Previous Message--
194.131.190.3
Make sure that you are booting the device into a ROM enabled mode. Check the mode pins.
: I am using the FDT to download a
: monitor in boot mode into the
: 2633F. The FDT reports success,
: but after cycling the power on the
: board the memory areas in FLASH
: are empty. The FDT even reports
: successful verification. Have I
: managed to enable a shadow RAM or
: what could be the problem? I
: haven't programmed the board more
: than some fifty times, so the
: FLASH shouldn't ben worn out.
: TIA
: Fredrik Lundberg
:
Message Thread:
« Back to thread