Posted by Andy Graham I have been using TextPad in this way for 18 months. (It is aware of the Gnu error message format, allowing one to click on error messages and to be taken to the file and line, rather like using an IDE.) If this helps anybody out there, I am using Windows 98 at home. That runs commands in a window using "Command.com" whereas the NT 4 system at (new) work uses "Cmd.exe". It can't be as straightforward as just not using NT though, as I have used this setup on an NT machine in the past extensively too. Andy G --Previous Message--
on January 15, 2003, 8:15:18, in reply to "Re: DuplicateHandle(In) failed"
212.103.226.163
Thanks, Dieter, but it was a fix rather than a work-around I was after.
: Try another editor.
: Like UltraEdit.
: --Previous Message--
: Having been using the H8 Gnu compiler
: for around 18 months without
: problem, I have recently (today!)
: started to use it at a new
: company.
: On running the compiler, I get the
: error: : process_easy:
: DuplicateHandle(In)
: failed (e=6)
: c:\H8Tools\bin\make: :
: Interrupt/Exception caught (code =
: 0xc0000005, addr = 0x41bf2a)
: This only happens if I run it within
: (say)TextPad and not if I run it
: from a command prompt.
: Any good ideas folks?
: TIA
: Andy G
: :
:
Message Thread:
« Back to thread