Re: 2328 program execution doesn't start

Posted by GA on January 14, 2003, 10:23:41, in reply to "Re: 2328 program execution doesn't start"
194.131.190.3

Is the memory map set correctly? Is it possible that the stack isn't in valid RAM? The MAP file output from the linker should help here. Can you paste the simple code example that you are having problems with? GA --Previous Message-- : Did you initialise the necessary : hardware ? e.g. The Bus controller : ? : -Yash : --Previous Message-- : Hi : I am developing a system using a h8s : 2328 : microcontroller. I have some : difficulties running a program : from on chip flash. The program : flashes ok (FDT 2.2 read verify) : but the execution doesn't start. The : program itself is a simple i/o pin : toggle, in which first the data : direction is set to the pin and : then the corresponding bit in data : register. The chip isn't in : standby mode or anything like that : : details: IAR embedded workbench 2.31 : (1.52a) : memory model: small : fdt 2.2 using 2318 kernel 18.3 Mhz : with direct connection : : : :

---

Message Thread: 2328 program execution doesn't start - Petri Uimonen January 13, 2003, 8:42:29 Re: 2328 program execution doesn't start - Yash January 14, 2003, 8:40:36 Re: 2328 program execution doesn't start - GA January 14, 2003, 10:23:41 Re: 2328 program execution doesn't start - Petriu January 17, 2003, 8:07:48 Re: 2328 program execution doesn't start - GA January 20, 2003, 9:59:49 « Back to thread

---

Post a Response

Evaluation Kit Support
Renesas Evaluation Boards are intended for evaluation of Renesas microprocessors only, not as development tools.