Re: 2328 program execution doesn't start

Posted by Yash on January 14, 2003, 8:40:36, in reply to "2328 program execution doesn't start"
203.129.230.91

Did you initialise the necessary hardware ? e.g. The Bus controller ? -Yash --Previous Message-- : Hi : I am developing a system using a h8s : 2328 : microcontroller. I have some : difficulties running a program : from on chip flash. The program : flashes ok (FDT 2.2 read verify) : but the execution doesn't start. The : program itself is a simple i/o pin : toggle, in which first the data : direction is set to the pin and : then the corresponding bit in data : register. The chip isn't in : standby mode or anything like that : : details: IAR embedded workbench 2.31 : (1.52a) : memory model: small : fdt 2.2 using 2318 kernel 18.3 Mhz : with direct connection : :

---

Message Thread: 2328 program execution doesn't start - Petri Uimonen January 13, 2003, 8:42:29 Re: 2328 program execution doesn't start - Yash January 14, 2003, 8:40:36 Re: 2328 program execution doesn't start - GA January 14, 2003, 10:23:41 Re: 2328 program execution doesn't start - Petriu January 17, 2003, 8:07:48 Re: 2328 program execution doesn't start - GA January 20, 2003, 9:59:49 « Back to thread

---

Post a Response

Evaluation Kit Support
Renesas Evaluation Boards are intended for evaluation of Renesas microprocessors only, not as development tools.