Posted by chee loong
on October 2, 2008, 16:03:02, in reply to "Re: Programming H83664 flash without debugger"
212.219.112.19
--Previous Message--
: We have the same problem with EDK3664.
: If one follows the instructions
: following the tutorials, the
: "Normal" project does not
: work in Release mode, but works in
: Debug mode.
:
: Is there a corresponding fix for the
: US version of EDK3664 (Board in a
: Bag)?
:
: Eswar
:
: --Previous Message--
: I had the same problem, however
: there
: is an upgrade on the Hitachi
: Microsystems website that fixes
: this problem
: This can be found at
:
:
: http://www.hmse.com/products/lem/support.htm
: Hope this helps
: --Previous Message--
: Hi all, we are using LEM for h83664,
: we
: have tried to program flash not
: for debug (without debug code)
: with initial windows of HDI for
: LEM. It doesn't work; reset vector
: and SP initialization are right,
: TEST and NMI pins are correctly
: connected. Any ideas ? (in debug
: mode the system works fine).
: TIA
: Carlo
: :
:
:
:
Message Thread:
« Back to thread