Re: Direct serial connection H8S2633

Posted by Domenico Antonio on January 4, 2006, 15:42:06, in reply to "Direct serial connection H8S2633"
151.41.164.43

--Previous Message-- : I am using a prototype of my board : with FDK3.1 with direct serial : connection and am not able to : connect, get the following message : : Connecting to device 'H8S/2633F' on : 'COM1' : Configuration: 'BOOT Mode' : connection - using emulated : interface : Opening port 'COM1' ... : Loading Comms DLL : Loaded Comms DLL : Initiating BOOT SCI sequence : Attempting 9600 : Attempting 4800 : Attempting 2400 : Attempting 1200 : Error No 15024: Boot failed : Unloaded Comms DLL : : I am using RX, TX and GND pins only. : : Any suggestions? : : I am pulling reset low, : then pulling MD2 low and FWE high : manually and taking reset high and : starting the flash sequence with no : result : I can see RX trying to autoadjust : going into RX pin SCI2 channel. : There is no response on TX pin SCI2 : channel . : : :

Link: http://iprsystems.it

---

Message Thread: Direct serial connection H8S2633 - Ajit April 8, 2004, 9:03:52 Re: Direct serial connection H8S2633 - Domenico Antonio January 4, 2006, 15:42:06 Re: Direct serial connection H8S2633 - GA April 8, 2004, 9:53:32 purchasing - dong wei May 12, 2004, 1:44:54 Re: Direct serial connection H8S2633 - ajit April 9, 2004, 0:03:10 Re: Direct serial connection H8S2633 - KT April 13, 2004, 13:04:26 Re: Direct serial connection H8S2633 - vijayargavalu December 26, 2005, 12:40:24 « Back to thread

---

Post a Response

Evaluation Kit Support
Renesas Evaluation Boards are intended for evaluation of Renesas microprocessors only, not as development tools.