[ Post a Response | High-performance Embedded Workshop Forum ]
Posted by GA on 21/3/2006, 10:19:31, in reply to "L1100" This is the linkers way of saying that the linker section information contains a section called "C" but there is nothing to go in it. The "C" section for constant data so to eliminate the warning create some constant data. GA --Previous Message--
62.73.170.19
Hi,
: Hi all,
: I'm new to the HEW 4, using the
: Standard Tool Chain 6.1.1.0 and I do
: have a problem setting up a new
: project.
: I'm using the wizard and I have
: already tryed several ways but I do
: always get the following message
: L1100 (W) Cannot find "C"
: specified in option
: "start"
: I don't ad any other code by my self
: but I do always get this message. I
: know that it has something to do if
: I write my code in C or C++.
:
: As much as I can see, the program
: works fine but it irritates my in
: some way.I would be satisfied if I
: compile and link my code without any
: warnings or errors.
:
: If some one could give my a hint I
: would appreciate it very much.
:
: Thank you.
:
: Christian
:
Message Thread
« Back to index