Posted by Tony D
on 5/31/2009, 12:30 pm, in reply to "Re: 63 falcon con. frame"
72.73.126.168
Jim,
I measured from the front spring bushing bolt hole to end of the frame where it is welded to the back panel (66 1/2") I also measured from front spring bushing hole to rear shackle hole (49"). I noticed that the shackle on this wagon frame rail has a mount and the shackle is then bolted to it as apposed to a bushing bolt hole like on sedans and convertibles. I believe that with exception of total length the basic configuration is the same. I can send you a picture but please research further so as not waste time and money if this isn't right. The rail is in excellent condition. i would want 50.00 plus shipping. I can send pictures if you would like.
Tony
--Previous Message--
:
:
: --Previous Message--
: I have on side from a 1962 wagon. I
: know that it is a little longer than
: the convertible. If you are
: inteested I will measure and compare
: dimensions of my convertible and let
: you. I parted a car out a few years
: ago and saved because it was so
: clean and rust free.
: Tony D
:
: --Previous Message--
: I am looking for frame rear rails
: for
: a 63 falcon convertible does anyone
: know where i can get them
:
:
:Yes Tony if you like to measure them
: and let me know and how much you
: want for them
:
:
Message Thread:
« Back to thread