Posted by J B Long
on 5/19/2008, 5:59 pm, in reply to "Re: JB... Question."
72.251.75.24
To swap the C4 from the 289 to the 200 you need to swap the bellhousing and torque converter. Make sure to get the early converter since the splines changed at some point in the late '60s. The kickdown linkage will be different also. JL
--Previous Message--
: JB, I have the C-4 in a 1964 Falcon
: Wagon, what I'm doing is changing
: the 1965 289 from the wagon and
: installing a 200 6 cylinder engine
: from a 1965 Ranchero. So now the
: question is will an mid 60s C-4
: tranny bolt up to a 200 engine?
: I should have made it a bit clearer.
: Thanks again for the replies.
:
: DMAC thanks for the tip,
:
Message Thread:
« Back to thread