Posted by David
on 11/11/2007, 6:33 am, in reply to "Re: side trim"
69.249.6.153
If you have the trim filler piece, there are notches in it where the mounting tabs go. It isn't exact but it will give an approximate location. The tabs slide in the stainless trim so exactness isn't crucial.
The only way I know how to make the square holes is to drill a 1/4 inch hole and use a needle file to make it square. (yes it takes forever) It may be easier to find a set of fenders that have the holes.
Make sure you don't lose the tabs. I have only found new ones from falconparts.com (They're $2 dollars a piece.
: --Previous Message--
: I'm going to be installing the
: stainless trim down the side of
: my'65 conv. there are no holes at
: this time, and am looking for an
: idea or trick to make sure I get it
: right the first time, as once I
: drill the holes, that's it, there's
: no going back. Does anyone know of a
: template or pattern available?
: I appreciate the help, Thanks, Bill
:
:
:
Message Thread:
« Back to thread