Posted by TBOT 405 --Previous Message-- Link: JOE B. SALES
on 10/3/2007, 7:12 am, in reply to "side trim"
24.8.233.143
THERE WAS NEVER , NEVER , A 65 CONVERTIBLE MADE WITHOUT HOLES IN THE SIDE FOR THE TRIM. THEY WERE SQUARE HOLES PUNCHED AT THE FACTORY. THE BODY SHELL , REAR Q'S , WILL HAVE THEM , MAYBE UNDER BONDO OR WELD , BUT THEY HAVE TO BE THERE. IF IT'S BONDO YOU MIGHT BE ABLE TO JUST KNOCK THEM OUT. IF YOUR DOORS AND FENDERS ARE ORIGINAL THEY TOO WILL HAVE THEM HIDDEN .... IT'S HARD TO DRILL SQUARE HOLES. MAYBE SOMEONE ELSE WOULD SUGGEST THE RIGHT WAY TO MAKE HOLES FOR TRIM. TOM FCA # 405 SINCE 1979
: I'm going to be installing the
: stainless trim down the side of
: my'65 conv. there are no holes at
: this time, and am looking for an
: idea or trick to make sure I get it
: right the first time, as once I
: drill the holes, that's it, there's
: no going back. Does anyone know of a
: template or pattern available?
: I appreciate the help, Thanks, Bill
:
Message Thread:
« Back to thread