Posted by Patrick M on June 3, 2009, 8:58 pm, in reply to "Re: ARB diff lockers"
211.26.93.225

Hey Ned, I'm pretty sure that I have the mounting bracket used to hold the actuating block in place while welding it to the axle housing. Your in Perth are you not? if so you can borrow it, don't forget that the housing has to be pre-stress while welding the block onto same. Regards:- Patrick M. --Previous Message-- : I've got the Maxi out of the old '84 RR and it : is a 28 spline shaft Maxi. : I think I'm going to have to make a new : block to weld to the axle housing though. : Will be too messy to cut it off the old one. : Ned : : :