Posted by peter r on September 1, 2008, 11:22 pm, in reply to " EAS ... Air Bags - springs - bellows - bags ?"
144.139.163.105

G`day All . Not long replaced some disc rotors and looking at them and thinking about the air spring , had a thought . With it assembled , cone bottom , bag mid and cone top . Put the bottom cone on rear rotor which is flat on floor , put one front rotor over top cone , centre of rotor is same diameter as cone outer , put a little air in , put another front rotor on , added a bit more air . Weight of Rotors balance on top held with one hand it`s finger regulates the air , chest pushes down adding extra pressure , other hand steers bottom of bag and aids the rolling of the bag over its self . Once thought of took about 2 mins per bag , thought time till thought of , weeks , on and off . Having the bags compressed this way will make fitting easier for me . Not sure when i`ll fit`em but got a kit to rebuild the valve block and some compressor mounts so maybe all at once , see hopw i feel . I intend to use loose/joined wires into the ecu plug to decompress system and fill each bag as needed as i haven`t got a kicker and think unless i have a huge problem may be able to work without but this will depend on the free P38A programs that are about and if they will work on earlier RR EAS . Cheers --Previous Message-- : Hi All , : : Anyone heard of or have a way of or can : think of a way of ...... : : Fitting the bag - bellow - spring part to : the cones , well not fitting to the cones . : : More specifically a way of getting them to : fold over its themselves . : : As a description ... Out of the car with : 10psi in the bags , we have the cones top : and bottom and the bag at full extention , : the lower part of the bag folds over its : self to allow for up and down movement . : : After any ideas on how to do it out of the : car .( nothing jumps out at me , this being : my reason for more mind power please ) : : Thanks : Peter. :