Long post and I say amazing a lot in this. My Sverlodv came from Globaltoys faster than expected. I was very pleased to see a big box so no fear of getting a small unordered placer item. However as I was bringing the box in I thought the shape was pretty weird for a ship, tank yes, ship no. I thought oh yeah the full hull was in two pieces but it was still weird. On opening the box I discovered those clear plastic “air pillows”, I took the top one off and discovered instead of a box a plastic bag like a grocery bag with the handles tied together. I pulled out the bag and discovered inside the bag were 5 separate smaller bubble bags. I pulled each out and could see the parts inside the individual bags. They were VERY well wrapped. I proceeded to open up one that I thought was the stern section, again very well wrapped. I was using an exacto knife to open the wrapping being somewhat careful when I suddenly realized, oh crap the hull has 3d printed railings and boat divots. I slowed down and pulled it out and to my amazement and relief the railings and divots had survived. I proceeded to the bow and repeated the process, this time I did have some racing damage but no big deal. I finished all the bags with no other damage. Let me tell you this ship is amazing in detail. Everywhere I look the detail is astounding. The main superstructure has 3d ladders going down each level of the deck at they are incredibly life like in size. The printed deck detail, hatches, rails, life rafts, ships hatches, it’s all there. The secondary guns, radars, gun directors all one piece with detail that just pops out. The twin 40mm look correct even in the box like “turret” the Soviet navy used. The two one piece masts are also pretty amazing in detail, the 3d spider webs attachments parts, if you know what I mean look a little daunting to cut off but other than that I think everything will be fine. I will have to do some work on mating the bow and stern together I did a quick check and they almost perfectly came together. The hull in some areas also has some fine remains of the 3d printing that will easy to be sanded down. The kit looks like the photos I have seen online but I am ecstatic about the model.
Responses