Torque Tube Question for Bill M
Posted by ricrx7
on 2/25/2018, 5:56 pm
Another issue with rear axle. The front of the housing is solid mounted and the front of the drive shaft is solid mounted a few inches in front of the housing mount. But the drive shaft is not in the center of the front housing opening, but at the bottom of the opening. My car is on jack stands under the spring wells, so it should be at ride height. It appears that there is a 3/8 spacer that could be removed from the housing mount to lower it. Or if I shorten springs, the angle will change and may open some space below the drive shaft. Thoughts? Thanks.
|