The trans mount needs replaced desperately and thought i had enough clearance to just loosten the mounts and jack the trans up - no dice so i gotta drop the crossmember.
I took the carpet up and felt around to see if the threads were sticking up but didnt find any - they are just in more blind nut holes underneath so lifting the carpet was for nothing. I sprayed and soaked and used an impact on low to go tighten and loosten to get them to budge but no dice. I tried to get them to turn as well with a 3/8" rachet but also no dice and I dont wanna snap them off.
Hopefully a local 1 stall garage guy can help me out on both problems. I mean if they snap off while in the lift its MUCH easier to drill... but I will take any and all suggestions in the meantime.
Message Thread
« Back to index