 |
|
Posted by MDee on May 23, 2005, 3:39 pm, in reply to "Sequencing a Roland SH32 with my RM1x!" --Previous Message--
84.68.43.104
At first the RM1x can appear to do strange preset changes to external midi equip. The solution is to get rid of the "phrase" term in the bank section of voice mode & this should stop it.
: Hi, i'm new to the rm1x scene having just picked up a 2nd hand
: one.
: My primary use was to sequence my Roland SH32 which is working
: well. I.e i can play sounds through the yamaha, record etc!
: However, when i exit the utility menu or press record or back,
: the sequencer sends a signal to the sh32 and the display of the
: sh32 changes from for example A11 to --- and no noise is heard
: until i manually change pattern on my sh32 where all my preset
: sounds are lost unless i've written them beforehand!
:
: I've tried to stop the yamaha sending any midi messages via the
: utility & set up menus but the problem persists! I've also
: played with the local settings on the sh32 eg turn off or mid1
: or mid2 but again the problem persists! Has anyone any idea
: whats happening here?
:
: Does the yamaha clash with the Roland? Please, please advise of
: any tips cause i'm pulling my hair out here!!!
:
: Simon
:
Message Thread:
« Back to thread
|