
[ FYI FORD - MustangSteve's Ford Mustang Forum ]
If you wish to contribute to support this site, email mustangsteve66@yahoo.com
REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.
- disc brake swap
Posted by Clint Lewis   on 10/27/2009, 7:15 pm 74.196.207.42
Does anyone know if the front disc brake spindles, rotors and pads from a 1969 Ford LTD will fit on a 1968 Mustang? I am going to attempt to do the swap but didn't want to go at it blind. A friend told me that the outer tie rod end size will be bigger but I am not sure about the upper and lower ball joint size or if the rotors will be too thick for a smaller car like the Mustang. I know the granda swap is the most popular but the junk yards have already been raided. Any information will be greatly appreciated. Clint
|
Post an Intelligent Response
|
- Re: disc brake swap
Posted by Dharl Bagley   on 10/30/2009, 5:03 pm, in reply to "Re: disc brake swap" 71.214.248.83
Clint, Steve is correct as I have recently been down the long hill of locating what will and will not work. I would go to ebay listing number 260497403986 and buy these since they will adapt over using the bracket kit from Mustang Steve. You could be into a complete front and rear kit for under $1000.00 which is cheap and the benifit and look is worth bragging. Downside you will need to run 17 inch rims though. Good luck as I just bought a complete set off of Wayne from this site. These guy's on this site are awesome. Way better than the Chevelle sites I have been on
|
Post an Intelligent Response
|
- Re: disc brake swap
Posted by Brian68s   on 11/4/2009, 10:24 pm, in reply to "disc brake swap" 209.216.191.84|
Granada, Maverick, Versailles, Monarch- there are many options. Just look around and you will find them.
|
Post an Intelligent Response
|
[ FYI FORD - MustangSteve's Ford Mustang Forum ]
REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.