[ Post an Intelligent Response | FYI FORD - MustangSteve's Ford Mustang Forum ]

If you wish to contribute to support this site, email mustangsteve66@yahoo.com REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.

Re: Do it in this order...

Posted by MustangSteve on 11/1/2009, 4:40 pm, in reply to "Re: Do it in this order..."
Forum Owner and Moderator

The lower control arm and the sway bar will hold it up. The sway bar will try to keep the lower control arm parallel to the one on the other side of the car. That is why you will have to push down on the spindle to get it to come out of the ball joint stud. Spindle will try to fall over and can stress the brake hose if you don't keep it in line, but it can't really go anywhere.

---

MustangSteve

http://www.mustangsteve.com
http://www.mustangsteve.com/My66FB_Signature_marks.jpg


---

Message Thread: Upper Ball Joints - Billkubi 10/31/2009, 9:24 pm They should ................... - Mustsed 11/1/2009, 1:19 am Re: They should ................... - Billkubi 11/1/2009, 8:47 am I start with separating................ - Mustsed 11/1/2009, 9:07 am Re: I start with separating................ - Billkubi 11/1/2009, 10:06 am Re: I start with separating................ - Billkubi 11/1/2009, 12:25 pm Do it in this order... - MustangSteve 11/1/2009, 11:50 am Re: Do it in this order... - Billkubi 11/1/2009, 12:18 pm Re: Do it in this order... - MustangSteve 11/1/2009, 4:40 pm Re: Do it in this order... - Billkubi 11/1/2009, 5:27 pm Re: Do it in this order... - Billkubi 11/2/2009, 8:40 am « Back to thread

---

Post an Intelligent Response

REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.