[ Post an Intelligent Response | FYI FORD - MustangSteve's Ford Mustang Forum ]

If you wish to contribute to support this site, email mustangsteve66@yahoo.com REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.

Re: Do it in this order...

Posted by Billkubi on 11/1/2009, 12:18 pm, in reply to "Do it in this order..."
65.9.183.32

I have the general idea, how far down will the lower control arm and spindle move? What does loaded mean??? As I understand it right now, the only thing holding the lower control arm and spindle in place while they are hanging suspended is the upper ball joint, is that correct???.

---

Message Thread: Upper Ball Joints - Billkubi 10/31/2009, 9:24 pm They should ................... - Mustsed 11/1/2009, 1:19 am Re: They should ................... - Billkubi 11/1/2009, 8:47 am I start with separating................ - Mustsed 11/1/2009, 9:07 am Re: I start with separating................ - Billkubi 11/1/2009, 10:06 am Re: I start with separating................ - Billkubi 11/1/2009, 12:25 pm Do it in this order... - MustangSteve 11/1/2009, 11:50 am Re: Do it in this order... - Billkubi 11/1/2009, 12:18 pm Re: Do it in this order... - MustangSteve 11/1/2009, 4:40 pm Re: Do it in this order... - Billkubi 11/1/2009, 5:27 pm Re: Do it in this order... - Billkubi 11/2/2009, 8:40 am « Back to thread

---

Post an Intelligent Response

REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.