[ Post an Intelligent Response | FYI FORD - MustangSteve's Ford Mustang Forum ]

If you wish to contribute to support this site, email mustangsteve66@yahoo.com REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.

Re: They should ...................

Posted by Billkubi on 11/1/2009, 8:47 am, in reply to "They should ..................."
65.9.180.126

what is the step by step process? First unbolt the 4 bolts Then take out the cotter pin and big nut then seperate the ball joint from the upper suspension arm or is the order different?? will the lower arm fall down????

---

Message Thread: Upper Ball Joints - Billkubi 10/31/2009, 9:24 pm They should ................... - Mustsed 11/1/2009, 1:19 am Re: They should ................... - Billkubi 11/1/2009, 8:47 am I start with separating................ - Mustsed 11/1/2009, 9:07 am Re: I start with separating................ - Billkubi 11/1/2009, 10:06 am Re: I start with separating................ - Billkubi 11/1/2009, 12:25 pm Do it in this order... - MustangSteve 11/1/2009, 11:50 am Re: Do it in this order... - Billkubi 11/1/2009, 12:18 pm Re: Do it in this order... - MustangSteve 11/1/2009, 4:40 pm Re: Do it in this order... - Billkubi 11/1/2009, 5:27 pm Re: Do it in this order... - Billkubi 11/2/2009, 8:40 am « Back to thread

---

Post an Intelligent Response

REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.