[ Post an Intelligent Response | FYI FORD - MustangSteve's Ford Mustang Forum ]
If you wish to contribute to support this site, email mustangsteve66@yahoo.com REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.
Posted by Bullet Bob
on 10/12/2009, 9:03 am, in reply to "door glass removal"
72.174.99.179
Remove the door panel.
With the window mostly up, remove the front window stop at the front of the lower window frame, where the window rides in the front guide.
At the rear of the door, above and below the latch, are two plugs (chassis plugs). Remove these with a screwdriver (don't scratch you paint) and loosen the rear window stop (allen head screw) so the stop can be moved out of engagement with the lower window frame. Then loosen the upper and lower rear guide bolts.
Remove the rubber window bumper at the bottom of the door.
Let the window all the way down and remove the fuzzies. Hopefully you were planning to replace them 'cause they'll be ruined by removal. Use care not to chip paint. Good luck.
Raise/lower the window so you can pry the regulator pins from the rollers. (they snap in). May want someone holding the window up while doing this.
You should now be able to lift the window/frame assembly up and out of the door.
You MIGHT be able to get the window out with the fuzzies in but I haven't tried that.
I think that's all but I'll keep thinking about it.
Good Luck,
BB
Why does everyone have time to do a job twice,
but nobody has time to do it once...RIGHT? J.Wesley Cooper
Message Thread:
« Back to thread
REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.