[ Post an Intelligent Response | FYI FORD - MustangSteve's Ford Mustang Forum ]

If you wish to contribute to support this site, email mustangsteve66@yahoo.com REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.

Thermostat housing

Posted by billkubi on 10/8/2009, 12:58 pm
65.9.175.11

1968 289 coupe Pulled the housing off and sure enough there was no thermostat installed, in cleaning the Chrome Plated housing I noticed that there was some deep pitting inside. Can I repair that with JB Weld???

---

Message Thread: Thermostat housing - billkubi 10/8/2009, 12:58 pm Re: Thermostat housing - billkubi 10/8/2009, 1:56 pm Find any genny Ford that will work...you'll be a lot happier. nm - Bullet Bob 10/8/2009, 2:11 pm Re: Find any genny Ford that will work...you'll be a lot happier. nm - O 10/8/2009, 2:35 pm MS - I'll take one - FriscoSteve 10/8/2009, 4:56 pm Yeah, repair that rascal right into the trash bin.............n/m - Tubo 10/8/2009, 5:35 pm Re: Thermostat housing - Al Newman 10/11/2009, 10:58 am Re: Thermostat housing - Ed Pitts 10/11/2009, 11:36 am Re: Thermostat housing - hmartin025 10/11/2009, 8:29 pm Actually... - Bullet Bob 10/11/2009, 9:38 pm Re: Thermostat housing - Mach1_Ron 10/12/2009, 7:51 am Re: Thermostat housing - Rudi 10/12/2009, 9:07 am Dang, Ron..... - Al Newman 10/12/2009, 4:04 pm Re: Dang, Ron..... - Jim Bowie 10/12/2009, 8:32 pm Re: Dang, Ron..... - Mach1_Ron 10/12/2009, 9:45 pm Re: Thermostat housing - glenns66 10/12/2009, 9:24 am « Back to thread

---

Post an Intelligent Response

REMEMBER!!! When posting a question about your Mustang or other Ford on this FORD MUSTANG FORUM, BE SURE to tell us what it is, what year, engine, etc so we have enough information to go on.