[ Post a Response | Putting Green Discussion Forum ]
Posted by Ivan
on 11/19/2008, 4:45 pm, in reply to "Re: back lapping sprocket attachment"
24.162.228.63
I made one today using a 4" length of PEX tubing and a 1/2" socket to fit inside. I bored out the opening of the tubing and put a hose clamp on it to secure it to the spindle on the mower. It works great and only cost me about 5 bucks to make. email me and I can send you the pics. ivant67@yahoo.com
--Previous Message--
: you have to remove the sprocket. To
: do so you may have to use a gear
: puller.
:
: --Previous Message--
: I have a 7 blade Mclane reel mower
: and
: have manual brushed lapping compound
: on each of the blades and spun the
: blades backward by hand to sharpen.
: Does anyone know a way to attached a
: cordless drill with some type of
: rigged up device to fit over the
: sprocket so it will spin backwards.
: I have seen the hand cranks but I do
: not see how they attach to the main
: axle and I don't believe the
: sprocket comes off at least easily.
: Thanks
:
:
:
Message Thread:
« Back to thread