A TR-3 door panel sourced from Moss, probably the worst POS I have ever worked with in over 45 years, and metalwork is a big part of my job rebuilding LBCs.
Not only was the overall side profile wrong, but also the horizontal break-line curve was incorrect radius, and the slab-sides weren't.
Normally this is all correctable but I quickly found that the material itself is extremely hard, pretty much unworkable without annealing. Nothing like OEM or BMH-approved panels that I've worked with before.
I lost about a days work on it before it went into the trash, where it belonged...
I don't know the manufacturer, it was red primer like yours.
You'll probably have to cut-and-weld vs reforming a couple areas, the lower skin standing proud of the body will likely be in the door frame.
Good luck!
Glen
--Previous Message--
: Reskinning my doors.
: Having a few issues I'm working
: through.
:
:
:
: See the rest at the following link
:
:
:
:
Responses