--Previous Message--
: Yes it's a fairly common problem, the
: lube is working by the splines as you
: suspect. A little dab of sealer on the
: back side of the big washer & nut
: should seal it up.
: If it's a later diff with the
: collapsible spacer pinion preload
: adjustment, be sure not to tighten it
: up any more than it was or it will
: screw up the pinion preload.
: Also make sure the vent hole is clear.
: Glen
:
: --Previous Message--
: Hi All.
: It seems my GT6 differential has
: sprung a leak. After all of last summer
: with everything high and dry, right
: away this spring I have gear lube in
: puddles under the car. After pulling
: off the driveshaft and checking the
: source of leak it appears that the seal
: and seal surface on the input flange
: are fine but somehow gear lube is
: getting to the front of the dif. by
: going between the splines of the pinion
: shaft and the splines of the flange
: and under the nut and washer at the
: front of the flange and getting flung
: around everywhere. Quite a lot of lube
: came out when I separated the
: driveshaft from the dif. flange. I've
: not seen this happen before. Are you
: guys familiar with this problem?
: P.J.
:
:
:
Thanks. That's what I did and it seems to be good so far. Wasn't sure if silicone would hold up for long though. Would you use permatex or Silicone?
P.J.
Responses