This is sort of a rhetorical question/comment. Online and in my Bentley manual I find references for the pressure plate to flywheel bolts being 5/16 UNF with a reasonable torque for that size. Unfortunately, the bolts are really 1/4 UNF socket heads. If you apply the specified (5/16") torque they are going to shear. Spitbits, Rimmer, and Canley all list part 146176 as the clutch cover screw but fail to mention its real size. I am just surprised no one else has run into this and mentioned it online. (Naahhh, I didn't break any and don't need any of the screws. I was just surprised to see the mistake both in the manual and online).
Doug L.
--Previous Message--
: I'm thinking that the short plug goes in
: front, check fit it and make sure it
: goes deep enough that it doesn't stand
: proud of the block face.
: