Glen
--Previous Message--
: Ummm...
: What brought this thread back to the
: top? I didn't realize until this post
: resurfaced that I have been checking
: this board for over 2 years!
:
: Regardless, I certainly agree that
: doing a real-world CC check of the
: piston volume is better than volume
: approximation by a mathematical or CAD
: based model.
:
: Doug L.
:
: --Previous Message--
: Thanks, Doug!
:
: But I would urge a final, conclusive
: check, to measure the dome volume
: in the bore, by buretting it.
: Removes all doubt about difficult
: measurements of dome parameters,
: complex formulae and calculations.
: John
:
:
: --Previous Message--
: Did you mean CRC?... which is just a
: book. I used my CAD package to verify
: the formula in my CRC handbook.
: However, CAD is only as accurate as the
: model you make and that requires
: assumptions along the way. Still... it
: can be a good sanity check.
:
: Doug L.
:
:
:
Responses