Glen
--Previous Message--
: Hi Glen,
:
: Yeh - Delco.
:
: So there "is" a way to
: separate the two plates? I don't
: understand your comment, "clip
: retaining the 2 on bottom". If I
: could clear those and what
: "looks" like some sort of
: press fit at the center hole, I'd be
: home free.
:
: Thanks again,
:
: Jim M
:
: --Previous Message--
: Jim if it's a Lucas, the breaker plate
: is
: held in by 2 posi-drive screws from the
: top, plate lifts out, separate by
: turning one in relation to the other
: until the large end of the hole lines
: up with the peg and they slide apart.
: You probably have the Delco. Screws
: (straight slot) either side hold clips
: and vacuum unit housing & retain
: breaker plate. Remove screws, lift off,
: clip retaining the 2 on bottom.
: HTH
: Glen
: ps- "customizing the rear
: wing"?
: This begs for pictures...
:
:
:
: --Previous Message--
: And now a problem for the wizards:
:
: I decided that the dizzy should be
: cleaned at least once every 45 years.
: The vaccum advance plate rotated
: smoothly, but with a little resistance
: before cleaning. After cleaning
: though, it is terribly balky and I
: can't get it to move using mouth
: suction, which I believe is enough. I
: can't figure out how to separate the
: two plates, so neither can I figure out
: how to get the rest of the gunk out of
: there.
:
: Anyone have some rabbits up their
: sleeves for this?
:
: As always - THANKS!
:
: Ciao - Jim M
:
:
:
:
Responses